Tap into any PA setup!
The ART HeadTAP headphone amp makes it easy to plug your headphones into any amplifier to create a direct output into your headphones. It features dual headphone outputs, and can be used in a daisy chain with other headphone amplifiers to create extra headphone outputs.

In ear Monitors Made Easy!
On stage in a full band scenario, it can often be difficult to hear yourself (or anyone else if you are a drummer). This unit can also be used to power in ear monitors, by taking a feed from the amplifier, and switching it to a headphone level signal. No longer do you have to rely on floor wedges turned up full ball, damaging your hearing and creating a world of feedback issues.

Control and Protection
A volume control regulates the headphone level and internal resistors keep the unit's impedance high enough to protect the headphones. It also protects the amplifier from encountering too low a load impedance while powering tap units & the speaker system, or several tap units by themselves.

Features

• Passive electronics allow an amp signal to power the headphones (no batteries required!)
  
• Parallel 1/4-inch stereo/mono output jack allows daisy-chaining taps and/or speakers.
• Dual 1/4-inch stereo/mono headphone jacks
• Stereo/mono input selector button
• Volume control

Specifications

• Power Requirements: Passive
• Input: 1/4" stereo/mono input jack
• Output: Dual 1/4" stereo/mono headphone jacks
• Dimensions: 95mm x 74mm x 40mm (3.75x2.875x1.5 inches)