SWAMP Combo XLR and IEC AU Plug Power Cable
By: Vic on 8 June 2015Bought these a while ago, but was lucky enough to get ones that came with piggyback power plugs. I cut off the IEC connectors and replaced with standard extension sockets. Then plugged in short piggyback to IEC cables. Now all the speaker cables are fully stackable powerwise which is great for distribution and loop in loop outs. Also easily extendable if I need a longer run.
By: Vic on 17 April 2015great quality cable and hardware , the sheathing also feels like it will stand the test of time. very handy for satellite speaker runs.
SWAMP Combo XLR Audio and IEC Power Cable
2 in 1 power and XLR audio cable for powered speakers. The power cable is fitted with an IEC-C13 connector (kettle plug) and 3-pin Australian mains plug. The audio cable is terminated with 3 pin XLR male and female connectors and is designed to carry a balanced mic or line level signal.
Ideal amount of Cable Spread / Separation
With 160cm of spread at the 'mixer' end of the cable, it is easy to connect to your mixer / PA XLR output as well as a power source. At the 'speaker' end there is 45cm of spread, perfect for a tidy setup into a powered / active speaker.
Perfect for Powered Speakers
This combo lead is the ideal solution for running powered speakers. Instead of rummaging through your crate for multiple leads and laying out separate power and XLR audio cables, this power/ XLR audio combo reduces the cable run to a single loom per speaker, cutting down the time and effort required for set up and pack down.
Power for your Mix Position
The XLR/IEC combo provides a loom that can serve to provide a power run and audio signal to and from your mix position when a multicore is either not required or not available. Typical scenario would be corporate events and functions where it is important for mix position to remain out of sight.
- Cable Spread: 160cm (XLR(f) end), 45cm (XLR(m) end
- Conductor Cores: 3*1.5mm2
- Outer Diameter: 8mm
- Power Connectors: IEC-C13 to 3 Pin AU Power Plug, Compliant with AS/NZS3112
- Audio Connectors: Yongsheng YS137N-B and YS136N-B
- Cable Colour: Black
Custom Label: SC-Combo-XLR-IEC
Shipping Weight: 2.2000