SWAMP Combo XLR and IEC AU Plug Power Cable - Bare Wire - 15m

Combo XLR Audio and IEC Power Cable - Unterminated AU Power Plug Included -  Requires installation by electrician.
2 in 1 power and XLR audio cable for powered speakers. The power cable is fitted with an IEC-C13 connector (kettle plug) and includes a 3pin piggyback connector that is unterminated. Requires electrician installation. The audio cable is terminated with 3 pin XLR male and female connectors and is designed to carry a balanced mic or line level signal.

Ideal amount of Cable Spread / Separation
With 160cm of spread at the 'mixer' end of the cable, it is easy to connect to your mixer / PA XLR output as well as a power source. At the 'speaker' end there is 45cm of spread, perfect for a tidy setup into a powered / active speaker.

Perfect for Powered Speakers
This combo lead is the ideal solution for running powered speakers. Instead of rummaging through your crate for multiple leads and laying out separate power and XLR audio cables, this power/ XLR audio combo reduces the cable run to a single loom per speaker, cutting down the time and effort required for set up and pack down.

Power for your Mix Position
The XLR/IEC combo provides a loom that can serve to provide a power run and audio signal to and from your mix position when a multicore is either not required or not available. Typical scenario would be corporate events and functions where it is important for mix position to remain out of sight.

Features:

• Cable Spread: 160cm (XLR(f) end), 45cm (XLR(m) end
• Conductor Cores: 3*1.5mm2
• Outer Diameter: 8mm
• Power Connectors: IEC-C13 to 3 Pin AU Power Plug, Compliant with AS/NZS3112
• Audio Connectors: Yongsheng YS137N-B and YS136N-B
• Cable Colour: Black

• Length: 15m