SWAMP 10 Channel Powered Mixing Desk - 2x 300W - 8 Mic Preamps - Graphic EQ
NOTE: Remote shown in image no longer included.
The M-series mixers from SWAMP boast a sleek, compact design in a durable lightweight housing at an affordable price. Featuring all the controls you'd expect from a modern mixing console, the M-series are a no nonsense workhorse suited perfectly for a gigging band, solo artist, function venue, or rehearsal studio. The M210-P model is also equipped with a built in power amplifier than can drive 300W of power to 2x passive speakers, along with the 19" rack mounting capability makes this an ideal all-in-one mixer/amp solution.
Powered Mixer with 2x 300W Output
The M210-P has a built in stereo power amplifier rated at 300W RMS @8ohm and 450W RMS @4ohm per channel. Designed primarily for passive speakers FOH rated between 200W - 300W RMS @8ohm. To send the main mix signal to your main left and right speakers, simply connect the two speakon plug outputs on the mixer to the inputs of your speakers using 2-core speaker cable with the appropriate plugs. A rear fan is in place to keep the amp cool when in use.
7-Band Graphic Equalizer
A 7-band EQ enables the main output to be tweaked for particular rooms and venues. Graphic equalizers are the main backbone for good sound in a venue, providing a clear representation of the frequency spectrum. They allow the user to cut certain frequencies that are prone to feedback, and boost certain frequencies that may be lost due to the acoustics of the room.
19" Rack Mountable - Rack Rails Included
The M-series mixing desks are all 19" rack mountable, with the rack rails required included with every model. The rack rails simply attach to the side of the mixer with 3 screws already present on the mixer, then it is ready to be placed into any 19 inch rack case or frame.
AUX / FX Sends and Routing
Equipped with an auxiliary (AUX) send, that allows an additional "mix" of channels to be sent from the mixing console to foldback speakers or outboard effects. Ideal for creating foldback mixes for on stage performers. Each channel can be set to have the signal sent to the AUX send either PFL or AFL (Pre Fader Level, After Fader Level). The FX send channel can also be used as a 2nd AUX send.
The M Series mixers also includes a stereo sub group, allowing for an alternative output of selected channels via the Sub 1-2 Out XLR's. The sub-group can also be routed into the main mix, allowing for channels sent to the sub-group to be added to the mix via a single fader.
Monitor and Headphone Outputs
The monitor output enables the main mix to be sent to an alternative set of speakers, mixing desk, or recording interface. While the headphone output allows the user to solo channels by pressing the 'PFL' or 'AFL' buttons, and listen to the main mix without the confusion of room acoustics getting in the way.
Quality Mic Preamps
Critical to the performance of any decent audio mixer are the in-built microphone preamps. The M-series preamps offer undistorted, noise-free gain with plenty of headroom, usually reserved for more costly mixing consoles and outboard preamps units.
In-Built Delay Effect
Each channel has an FX control knob that will send the signal to the in-built 'delay' effect processor. There is a single 'reverb like' delay effect that is highly controllable via the FX, Del and Rep knobs. The FX knob controls the prominence of the delayed signal, while the delay time and fade out of the delay are controlled by the 'Del' and 'Rep' knobs respectively.
3 Band EQ Channel Strip
Each channel strip has a standard 3-band EQ with Bass, Mid and High controls. 15dB of level control each way gives the audio engineer plenty to work with.
- 8 Mic Preamps
- 2 Stereo Line inputs
- 7-band Main Mix EQ
- 1 AUX / Monitor send channel (2 if FX used as AUX)
- On board Effects processor
- On board USB/SD recorder
- Headphone Output
- Supplies 48V Phantom Power
|Maximum Input Level:||
|Maximum Output Level:||Main XLR: +26dBu
|Meters:||3 Colour LED, quasi peak response|
|Master Meter:||12 Segment, -30dB to Clip|
|Channel Meter:||Green LED, Signal Indication|
|Frequency Response||+/-0.5dB, 20Hz - 30KHz|
|Mic CMRR at 1KHz:||>75dB Typical|
|THD+n at +14dBu at 1KHz:||Mic to mix out <0.01%|
|Crosstalk (@ 1KHz):||
Fader Shutoff >85dB
|Noise, rms 20Hz to 20KHz:||
Mic Input EIN -122dBu
High: Shelving +/-15dB - 12KHz
XLR balanced, pin-2 hot, 2kOhm, -60 to +14dBu
|Stereo Channel||TRS unbalanced, tip hot, 10kOhm, -40 to +14dBu|
|2-track Return||RCA unbalanced, 4kOhm, -2dBu|
|2-track Send||RCA unbalanced, <75Ohm, -2dBu|
|L/R Output||XLR balanced, pin-2 hot, <75Ohm, +4dBu
|Sub 1-2 Output||XLR balanced, pin-2 hot, <75Ohm, +4dBu
|FX / Aux Output||TRS unbalanced, tip hot, <75Ohm, -2dBu
|Power Amplifier||2x 300W RMS @8ohm, 2x 450W RMS @4ohm|
|Headphones||TRS, tip L, ring R, 30-600 Ohm recommended|
|Headphones||TRS, tip L, ring R, 30-600 Ohm recommended|
|Power Consumption:||40 Watts|
|Power Supply:||110-240VAC, 50/60Hz|
Swamp M210-P - Full featured and powerful for it'sBy: John NOLAN on 27 January 2020Changing needs and fatigue from lugging heavy equipment to smaller venues induced me to unload my 24 channel mixer and heavy power amp and EQ/FX rack. I wished to hang onto my relatively compact FOH (unpowered)speakers so a modern lightweight powered mixer was required. I had my eye on a couple of better known brands but the features offered by this unit and power rating at a significantly lower price caught my attention. I had purchased from Swamp on previous occasions and I put my faith in the belief that the company would not put its name on an inferior product. The M210-P arrived one day ahead of schedule, securely packaged and basically required only to have speakers plugged in and connected to power. The only audible noise is the fan which is negligible in a live context. The channels have plenty of headroom and cater for a 4 piece band very well. It has a few refinements a lot of powered mixers do not including mute buttons (important for live mixing) 3 band EQ on all imput channels and a simple but effective 7 band EQ on the main outputs. Setting up the gain on both mike and line inputs was a breeze and while the in-built FX (delay) lacks any presets it was possible to set up a useful reverb like effect on the vocal mike inputs. There are a couple of limitations which are not surprising for a desk of this size. There is only one pre-fade aux send so only one dedicated foldback mix can be achieved. There are two sub-groups (another bonus) which could be used for monitor sends although they are post-fade. The other limitation is that the power amp section can only be used for the main mix. This is not a problem to me as all our foldback speakers are powered but if one wanted to rout one side of the power amp for foldback, this cannot be achieved. A totally unexpected bonus is that a bluetooth player is included enabling you to play music from your phone or iPod. Not only that but it can record the performance to an SD card or USB stick. This last feature presupposed that the whole band is running through the mixer which is theoretically possible with a small band. The M210-P had its first appearance in a venue yesterday (prior to that used for rehearsal) and performed impeccably with ample power to fill a medium sized function space. I think Swamp should be commended for sourcing such a well designed and flexible mixer amp at such an attractive price.
By: Mr. Philip Gemmell on 9 January 2016Excellent advice and service from Swamp staff. Really enjoying the use we get from the powered desk.
By: Ian Searle on 8 May 2015Terrific unit and a good price. I bought it as a PA system. It suits our purpose very well.
By: Mal Salter on 22 March 2015The service was excellent, The delivery was fast & when we got the product it was packed good.We will be ordering all our stuff from Swamp in the future.
By: Mr. dwayne smith on 2 January 2015m210 powered mixer , well this is great value for money, i use it in my home studio and put it threw my pc and i all so jam out loud with it .thank you swamp very happy 10 out of 10