• SWAMP 6 Channel Mixing Desk - 4 Mic Preamps - Graphic EQ - Bluetooth

    In Stock
    SAVE 10%
    Sale Ends:

    4 XLR Mic Preamp Inputs - 2x Stereo 1/4" Inputs. 7-Band Graphic Equalizer, Bluetooth connectivity and rack rails for 19" rack mounting. The M-series mixers from SWAMP boast a sleek, compact design in a durable lightweight housing at an affordable price.

    NOTE: Remote shown in image no longer included.

    SWAMP M206 Mixing Desk - 4 XLR Mic Preamp Inputs - 2x Stereo 1/4" Inputs
    The M-series mixers from SWAMP boast a sleek, compact design in a durable lightweight housing at an affordable price. Featuring all the controls you'd expect from a modern mixing console, the M-series are a no nonsense workhorse suited perfectly for a gigging band, solo artist, function venue, or rehearsal studio. Includes audio playback module

    7-Band Graphic Equalizer
    A 7-band EQ enables the main output to be tweaked for particular rooms and venues. Graphic equalizers are the main backbone for good sound in a venue, providing a clear representation of the frequency spectrum. They allow the user to cut certain frequencies that are prone to feedback, and boost certain frequencies that may be lost due to the acoustics of the room.

    19" Rack Mountable - Rack Rails Included
    The M-series mixing desks are all 19" rack mountable, with the rack rails required included with every model. The rack rails simply attach to the side of the mixer with 3 screws already present on the mixer, then it is ready to be placed into any 19 inch rack case or frame.

    AUX / FX Sends and Routing
    Equipped with an auxiliary (AUX) send, that allows an additional "mix" of channels to be sent from the mixing console to foldback speakers or outboard effects. Ideal for creating foldback mixes for on stage performers. Each channel can be set to have the signal sent to the AUX send either PFL or AFL (Pre Fader Level, After Fader Level). The FX send channel can also be used as a 2nd AUX send.

    The M Series mixers also includes a stereo sub group, allowing for an alternative output of selected channels via the Sub 1-2 Out XLR's. The sub-group can also be routed into the main mix, allowing for channels sent to the sub-group to be added to the mix via a single fader.

    Monitor and Headphone Outputs
    The monitor output enables the main mix to be sent to an alternative set of speakers, mixing desk, or recording interface. While the headphone output allows the user to solo channels by pressing the 'PFL' or 'AFL' buttons, and listen to the main mix without the confusion of room acoustics getting in the way.

    Quality Mic Preamps
    Critical to the performance of any decent audio mixer are the in-built microphone preamps. The M-series preamps offer undistorted, noise-free gain with plenty of headroom, usually reserved for more costly mixing consoles and outboard preamps units.

    In-Built Delay Effect
    Each channel has an FX control knob that will send the signal to the in-built 'delay' effect processor. There is a single 'reverb like' delay effect that is highly controllable via the FX, Del and Rep knobs. The FX knob controls the prominence of the delayed signal, while the delay time and fade out of the delay are controlled by the 'Del' and 'Rep' knobs respectively.

    3 Band EQ Channel Strip
    Each channel strip has a standard 3-band EQ with Bass, Mid and High controls. 15dB of level control each way gives the audio engineer plenty to work with.

    Built in Audio Playback Module with Bluetooth, USB and SD Card
    The M series includes an on board MP3 player / audio playback module that be connected to via Bluetooth or direct, wireless connections to any smartphone, or laptop for simple audio playback. Or you can also connect using a USB drive or SD memory card. It's also an ideal choice for gigging bands who want to play smooth tunes between sets to keep the crowd hungry.


    • 4 Mic Preamps
    • 2 Stereo Line inputs
    • 7-band Main Mix EQ
    • 1 AUX / Monitor send channel (2 if FX used as AUX)
    • On board Effects processor
    • On board USB/SD recorder
    • Audio playback module supporting Bluetooth, USB stick or SD card
    • Headphone Output
    • Supplies 48V Phantom Power


    Maximum Input Level:

    Mic +24dBu
    Line: +24dBu

    Other Line: +20dBu

    Maximum Output Level: Main XLR: +26dBu
    TRS +20dBu
    Meters: 3 Colour LED, quasi peak response
    Sensitivity: 0VU=+4dBu
    Master Meter: 12 Segment, -30dB to Clip
    Channel Meter: Green LED, Signal Indication
    Frequency Response +/-0.5dB, 20Hz - 30KHz
    Mic CMRR at 1KHz: >75dB Typical
    THD+n at +14dBu at 1KHz: Mic to mix out <0.01%
    Crosstalk (@ 1KHz):

    Fader Shutoff >85dB
    Mute Shutoff >85dB
    Inter-Channel >82dB

    Noise, rms 20Hz to 20KHz:

    Mic Input EIN -122dBu
    Residual output noise <-90dB
    Main mix fader unity <-82dBu
    Aux mix noise <-82dBu

    3-Band EQ

    High: Shelving +/-15dB - 12KHz
    Mid: Peaking +/-15dB - 2.5KHz
    Low: Shelving +/-15dB - 80Hz

    Mono Channel

    XLR balanced, pin-2 hot, 2kOhm, -60 to +14dBu
    TRS balanced, tip hot, 10kOhm, -40 to +14dBu
    XLR Phantom +48V

    Stereo Channel TRS unbalanced, tip hot, 10kOhm, -40 to +14dBu
    2-track Return RCA unbalanced, 4kOhm, -2dBu
    2-track Send RCA unbalanced, <75Ohm, -2dBu
    L/R Output XLR balanced, pin-2 hot, <75Ohm, +4dBu
    (+22dBu max)
    Sub 1-2 Output XLR balanced, pin-2 hot, <75Ohm, +4dBu
    (+22dBu max)
    FX / Aux Output TRS unbalanced, tip hot, <75Ohm, -2dBu
    (+18dBu max)
    Headphones TRS, tip L, ring R, 30-600 Ohm recommended
    Power Consumption: 40 Watts
    Power Supply: 110-240VAC, 50/60Hz
    Dimensions: 360mm(w)x322mm(d)x78mm(h)
    View PDF brochure for SWAMP 6 Channel Mixing Desk - 4 Mic Preamps - Graphic EQ - Bluetooth

    Couldn't be happier!

    By: on 6 November 2020
    I bought this a few years ago for the home karaoke/party set up and it has exceeded all expectations, especially considering the budget price. Produces clean sounds and the recording and mp3 playback capabilities, not to mention Bluetooth connectability, are great! My more expensive 2 channel Behringer with not even halve the features crapped out on me (might have been a power surge?) and as a quick replacement, I found this mixer on the Swamp website and figured at that price, if it only just does the job I'm happy. It is still running some 3 year later and as I mentioned before, is feature rich for the money you pay. I will have no hesitation purchasing another one were this to eventually fail.

    review for SWAMP 6 Channel Mixing Desk

    By: on 21 November 2016
    I bought this mixer as a starter as i am gust starting out in the world of professional audio. Because I am only starting out i have a tight budget the swamp m206 is at an affordable price. most other 6 Chanel mixers are about $400 but the m206 is only $200. Over all this is a hight quality mixer for only half the price of other mixers of this quality.


    By: on 21 November 2016
    Purchased this unit for a home studio set up. Has all I need for recording into Garage Band and plenty of options for rehearsal. Takes inputs from guitar practice amp, metronome/click track, pc, mic's etc. The EQ is very versatile & 'warm'. It has great features that I thought I would have to pay more to get. Overall, this is a very nice unit & fits the application nicely at a very good price. Swamp have done well with these. Highly recommended.
    By: on 9 October 2015
    i am very satisfied with my purchase. I am in france and the package arrived within no more than one week, sooner than expected.
    By: on 27 December 2014
    This is a fantastic unit. The on board recording facilities and intuitive design makes this easy to use. Great for podcasting. I highly recommend this product.

    Write a product review

    Product Enquiry Form Complete this form to email us your enquiry.


    MPN: M206

    Sign Up For Our Newsletter

    Copyright © 2020 SWAMP Industries